◆
CRM-III
Suraksha
Pathshala
SAFETY LEARNING HUB · BOKARO STEEL PLANT
Home
Safety Academy
Unit Courses
Quiz Arena
Library
Safety Bytes
Knowledge Hub
☎ Emergency
Login
← All topics
CRM-III · SAFETY QUIZ
Crane & Lifting
Select a level and answer each question. You can revisit answers before submitting.
13 published questions
All
13
Foundation
6
Practical
3
Advanced
4
0 / 10 answered
Choose the best answer
QUESTION 01 / 10
Foundation
What is the safest rule for personnel near a suspended crane load?
A
Stay clear of the suspended load and its travel path
B
Stand below the load briefly if wearing a helmet
C
Hold the load by hand to prevent rotation
D
Walk between the load and a fixed column
QUESTION 02 / 10
Practical
During a trial lift, a coil begins to tilt unexpectedly. What should the operator do?
A
Continue lifting to let it settle
B
Ask a worker to push the coil upright
C
Lower it safely, stop and reassess the rigging and centre of gravity
D
Increase trolley speed to stabilize it
QUESTION 03 / 10
Advanced
A load centre of gravity is offset from the lifting point. What hazard should the lift plan address?
A
Unexpected tilting or rotation
B
Reduced electrical voltage
C
Excessive ventilation
D
Incorrect paint marking
QUESTION 04 / 10
Advanced
Maintenance is underway on a middle EOT crane. Where does the cited standard specify rail stops?
A
On one side, immediately against the crane
B
Only at the far end of the shop
C
On both sides, six metres away from the crane
D
At any distance chosen by the adjacent operator
QUESTION 05 / 10
Practical
Before a coil lift, a sling shows broken wires and deformation. What is the correct response?
A
Use it for a lighter load
B
Remove it from service and report the defect
C
Wrap it with tape
D
Shorten the lifting distance
Question reference image
QUESTION 06 / 10
Advanced
Before handing an EOT crane back after maintenance, which action is specifically required?
A
Leave the warning flags in place for the next shift
B
Inspect the crane, remove loose items, restore guards and complete controlled handover
C
Restart immediately when the last mechanic descends
D
Ask adjacent cranes to move the repaired crane
QUESTION 07 / 10
Foundation
Who may operate an EOT crane under the inter-plant standard?
A
Any employee with a valid gate pass
B
Only a designated or specially trained and authorized competent person
C
A contractor supervisor regardless of training
D
Any person familiar with the pendant buttons
QUESTION 08 / 10
Practical
A rigger finds a sling with damaged strands and an unreadable identification tag. What is the correct action?
A
Use it only for a lighter load
B
Wrap tape around the damaged section
C
Use it if the lift lasts less than one minute
D
Remove it from service and report it for inspection or replacement
QUESTION 09 / 10
Foundation
A coil is being lifted from the receiving yard. Which arrangement best reduces rolling and struck-by hazards?
A
Secure coils on suitable saddles and keep people in marked safe walkways
B
Allow workers to guide the suspended coil by hand underneath
C
Store coils upright without restraint to save space
D
Disable audible warnings to avoid distraction
QUESTION 10 / 10
Advanced
A lift uses a crane, lifting beam and slings with different rated capacities. Which principle governs the lift?
A
The permissible load is limited by the lowest-rated applicable component in the actual configuration
B
The crane capacity alone determines the permissible load
C
The sling rating can be ignored if a lifting beam is used
D
The combined sum of all component ratings determines the load limit
Question navigator
Green = answered · Blue = current
← Previous
Question 1
Next →
Submit & review →
⌂
Home
▤
Learn
▣
Units
✎
Share
☎
Emergency