Quiz · Suraksha Pathshala

QUESTION 01 / 10Foundation

A coil is being lifted from the receiving yard. Which arrangement best reduces rolling and struck-by hazards?

ASecure coils on suitable saddles and keep people in marked safe walkwaysBAllow workers to guide the suspended coil by hand underneathCStore coils upright without restraint to save spaceDDisable audible warnings to avoid distraction

QUESTION 02 / 10Advanced

Maintenance is underway on a middle EOT crane. Where does the cited standard specify rail stops?

AOn one side, immediately against the craneBOnly at the far end of the shopCOn both sides, six metres away from the craneDAt any distance chosen by the adjacent operator

QUESTION 03 / 10Foundation

Before lifting a heavy coil with a C-hook, what must be confirmed?

AOnly that the crane motor startsBThe coil weight, C-hook rating, correct engagement and load balanceCThat the lifting speed is at maximumDThat a worker can guide the coil from underneath

QUESTION 04 / 10Practical

A rigger finds a sling with damaged strands and an unreadable identification tag. What is the correct action?

AUse it only for a lighter loadBWrap tape around the damaged sectionCUse it if the lift lasts less than one minuteDRemove it from service and report it for inspection or replacement

QUESTION 05 / 10Foundation

What is the safest rule for personnel near a suspended crane load?

AStay clear of the suspended load and its travel pathBStand below the load briefly if wearing a helmetCHold the load by hand to prevent rotationDWalk between the load and a fixed column

QUESTION 06 / 10Advanced

A load centre of gravity is offset from the lifting point. What hazard should the lift plan address?

AUnexpected tilting or rotationBReduced electrical voltageCExcessive ventilationDIncorrect paint marking

QUESTION 07 / 10Foundation

Why must people stay outside the suspended-load zone?

AThe load may fall or move unexpectedlyBIt makes the crane move fasterCIt reduces the noiseDIt improves lighting

Visual reference for question 7 — Question reference image

QUESTION 08 / 10Practical

Before a coil lift, a sling shows broken wires and deformation. What is the correct response?

AUse it for a lighter loadBRemove it from service and report the defectCWrap it with tapeDShorten the lifting distance

Visual reference for question 8 — Question reference image

QUESTION 09 / 10Foundation

An EOT crane’s safe working load marking is unreadable from the shop floor. What should be corrected?

APaint the crane a brighter colourBIncrease the horn volumeCRemove the crane identification plateDRestore clearly visible identification and SWL markings

QUESTION 10 / 10Advanced

A lift uses a crane, lifting beam and slings with different rated capacities. Which principle governs the lift?

AThe permissible load is limited by the lowest-rated applicable component in the actual configurationBThe crane capacity alone determines the permissible loadCThe sling rating can be ignored if a lifting beam is usedDThe combined sum of all component ratings determines the load limit

Crane & Lifting